beautypg.com

Raypak XPAK 85 User Manual

Page 51

background image

51

17. FAULT CODES
When the boiler detects a temporary fault condition, the
appropriate code is shown flashing on the display. If/when the
fault code is final, the pump will perform a 60-second post
circulation and the red LED will be illuminated.

CODE

CAUSE

ALARM TYPE

ACTION

AL10

Ignition failure/not flame sensed,

Final

Reset, check appliance operation

condense sensor activated

AL20

Limit thermostat fault, blocked flue switch,
flue thermostat

Final

Reset, check appliance operation

AL21

External device fault (UHT/CPA)

Final

Reset, check appliance

AL26

Return temperature too high

Final

Reset, check pump, ensure there is sufficient
flow sensor temperature). Circulation around
heating circuit/s

AL28

Temperature differential inverted

Final

Reset, check pump, ensure there is sufficient

(return sensor temperature higher than

circulation around heating circuit/s thermistors

flowsensor temperature)

AL29

Flue sensor over temperature lock out

Final

Reset check appliance operation

AL34

Fan blower signal fault

Final

Reset check appliance operation, check fan

AL40

Insufficient system water pressure

Final

Check/refill system pressure, reset, check

appliance operation

AL41

Insufficient system water pressure

Temporary

Check/refill system pressure, check appliance
operation

AL52

Internal fault

Final

Reset, check boiler operation

A

L55

Jumper tag fault

Final

Check jumper tag configuration

AL60

Jumper tag fault

Temporary

Check jumper tag configuration

AL71

Primary (flow) sensor fault

Temporary

Check primary thermistor, check wiring

AL73

Return sensor fault

Temporary

Check return thermistor, check /wiring

AL74

Variation on temperature of primary

Final

Reset, check boiler operation, check
and/or return too high pump, ensure there is
sufficient circulation around heating circuit/s

AL79

Flow temperature too high, or

Final

Reset, check appliance operation, check

temperature differential between

thermistors

primary and return too high

AL91

The main heat exchanger need to be

Advice

Call the Raypak technical service

cleaned