Runco CINEWIDETM VX-3000D User Manual
Vx-3000d series
Table of contents
Document Outline
- RuncoCare™ Standard Two Year Limited Warranty
- Important Safety Instructions
- Compliance Information
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Primary Projection Lens (VX-3000d Ultra only)
- 3.5 Installing the Optional CineWide/AutoScope Lens Mount
- Installing the AutoScope Lens Motor
- Installing the Fixed CineWide Base Plate (Prismatic Lens)
- Installing the Fixed CineWide Base Plate (Cylindrical Lens)
- 3.6 Mounting the VX-3000d
- 3.7 Connections to the VX-3000d and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-3000d
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-volt Trigger Outputs to External Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting to AC Power
- 3.8 Turning on the Power
- 3.9 Primary Lens Adjustments
- 3.10 Adjusting the Picture Orientation
- 3.11 Installing and Adjusting the CineWide Anamorphic Lens
- Cylindrical Anamorphic Lens Installation and Adjustment
- Figure 3-23 . Cylindrical Anamorphic Lens Mounting Assembly - Exploded View
- Attaching Lens Mounting Assembly to Lens Motor Carriage Plate or Fixed CineWide Base Plate
- Configure Lens Motor Trigger (VX-3000d/CineWide with AutoScope only)
- Adjusting the Horizontal (X) Lens Position
- Adjusting the Height (Y)
- Adjusting the Pitch (Angle)
- Adjusting the Yaw
- Geometry
- Focus
- Whitney (Prismatic) Anamorphic Lens Installation and Adjustment
- Cylindrical Anamorphic Lens Installation and Adjustment
- 4. Operation
- 5. Maintenance and Troubleshooting
- 6. External Control
- 7. Specifications