Runco CINEWIDETM VX-3000D - Manual (Page 103)

Maintenance and Troubleshooting
VX-3000d Series Installation/Operation Manual 87
PRE
L
IMINAR
Y
Image appears “washed out”
and/or dark areas appear too
bright. • Brightness is set too high. • Lower the brightness
setting.
A projected image from a
DVD is split or otherwise
scrambled. • DVD player is connected
to the Component input
and set to progressive
scan mode.
• Turn off progressive scan
on the DVD player.
Image is blurred. • The lens is not correctly
focused.
• Adjust the focus with the
remote control.
Colors in the image are
swapped; for example, reds
appear blue or vice versa. • The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to
the wrong inputs on the
VX-3000d.
• Ensure that the source
outputs are connected to
the correct VX-3000d
input.
POWER LED lights solid red. • Internal failure. • Please contact your Runco
dealer for assistance.
LAMP LED lights solid red. • The lamp has failed or
exceeded its usage life.
• Replace the lamp with a
new one.
TEMP LED lights solid red. • VX-3000d internal
temperature is too high or
one or more fans have
failed.
• Power off the VX-3000d
and allow it to cool down.
Ensure that the intake and
exhaust vents are not
blocked. Turn the
projector back on. If the
problem persists, please
contact your Runco dealer
for assistance.
Table 5-1. Troubleshooting Chart (continued)
Symptom Possible Cause(s) Solution