Runco LIGHTSTYLE LS-3 - Manual (Page 54)

Operation
38 Runco LS-3/LS-5 Installation/Operation Manual
PRE
L
IMINAR
Y
4.4
Using
Picture-In-Picture (PIP) For PIP purposes, there are three groups of inputs
separated by their display modes:
• Video (SD) group: Video, S-Video and SCART
inputs.
• Graphic (HD) group: Component 1, Component 2 and RGB inputs.
• Digital Video group: HDMI 1 and HDMI 2 inputs.
PIP shows one input from any of these groups within or beside one input from either of the
other two groups.
• Press PIP to enable the PIP function. Once enabled, press PIP repeatedly to select the
desired PIP source or turn PIP off.
• Press SWAP to swap the main and PIP images.
For more information, refer to PIP Position on page 59.
For each source, Table 4-1 shows which of the other sources are available as a PIP
source.
Table 4-1. Available Main and PIP Source Combinations
PIP Input Source
VIDEO S-VIDEO SCART COMP 1 COMP 2 RGB
HDMI
2
HDMI
1
Main Input Source
VIDEO
– – –
√ √ √ √ √
S-
VI
DE
O
– – –
√ √ √ √ √
SC
A
R
T
– – –
√ √ √ √ √
COMP
1
√ √ √
– – –
√ √
COMP
2
√ √ √
– – –
√ √
RGB
√ √ √
– – –
√ √
HD
MI
2
√ √ √ √ √ √
– –
HD
MI
1
√ √ √ √ √ √
– –
Notes:
1. “
√” means that that source is available as a PIP source with a given main source; “–” means that
it is not.
2. Disabled sources (refer to Source Enable on page 58) are not available as PIP sources.
PIP SWAP LIGHT