3 ls-3/ls-5 remote control, Ls-3/ls-5 remote control, Pre l iminar y – Runco LIGHTSTYLE LS-3 User Manual
Page 27
Runco LS-3/LS-5 Installation/Operation Manual
11
PRE
L
IMINAR
Y
2.3
LS-3/LS-5 Remote
Control
1.
ON
Use this button to turn
the projector on.
2.
OFF
Use this button to turn
the projector off.
3.
Source Selection
Buttons (1-5):
Press to select a video
source. By default, these
buttons are assigned as
follows: 1 = HDMI 1; 2 =
HDMI 2; 3 =
Component 1; 4 =
S-Video; 5 = Video.
However, you can assign
each button to any
source you wish.
4.
Cursor Keys (
,
,
,
)
Use these buttons to
select items or settings,
adjust settings or switch
display patterns.
ENTER
Press to select a
highlighted menu item or
confirm a changed
setting.
5.
Aspect Ratio Selection Button
Press this button repeatedly to select one of the following aspect ratios:
16 : 9: For viewing 16:9 DVDs or HDTV programs in their native aspect ratio.
Letterbox: For viewing LaserDisc movies or non-anamorphic DVDs on a 16:9
screen.
4 : 3: Scales the input signal to fit 4:3 sources in the center of the screen.
4:3 Narrow: Scales the input signal to fit 4:3 sources in the center of the screen when
using an anamorphic lens.
Native: Displays source image in its native resolution without re-sizing or overscan.
6.
MENU
Press this button to show or hide the OSD controls.
7.
Memory Preset Buttons (M1 / M2 / M3)
Press to recall settings for the current input from one of three memory presets. By
default, these buttons are assigned as follows: M1 = User Memory 1; M2 = User
Memory 2; 3 = ISF Night. However, you can assign each button to any memory
preset you wish.
ON
l
POWER
OFF
1
4
2
3
5
M1
GAMMA
PIP
M2
OS
SWAP
M3
SHARP
NR
LIGHT
▲
▼
▲
▼
ENTER
MENU
USER MEMORY
SOURCE
9
1
4
2
3
5
7
6
8
10