6 connections to the ls-3/ls-5, Connector panel access, Connections to the ls-3/ls-5 – Runco LIGHTSTYLE LS-3 User Manual
Page 40: Pre l iminar y
24
Runco LS-3/LS-5 Installation/Operation Manual
PRE
L
IMINAR
Y
3.6
Connections to the
LS-3/LS-5
Proceed as follows to connect the LS-3/LS-5 to your video sources, external controller(s)
– if present – and AC power.
When connecting your equipment:
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel Access
Using a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.
Then, remove the rear compartment cover by
tilting it upward.
➤
This manual is related to the following products: