Ricoh H5676 - Manual (Page 50)

Sending Scan Files by Scan to Folder
42
2
Preparation for Sending by Scan to Folder
This section explains the preparation and settings for sending scan files by Scan
to Folder.
Important
❒ This function is available only when Function Upgrade Option is installed.
❒ Files can be sent to shared folders on client computers.
❒ Files can also be sent to FTP servers if any exist on the network.
❒ Files can also be sent to NetWare servers if any exist on the network.
A
Connect the machine to the network.
Connect the machine to the network using an Ethernet or IEEE 1394 cable, or
wireless LAN (IEEE 802.11b).
B
Make the necessary network settings in [System Settings]
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine’s IPv4 address and subnet mask.
• Specify the IPv4 gateway address.
• In [Effective Protocol], enable [IPv4].
• To send files to shared folders, enable [SMB] in [Effective Protocol]. To send
files to NetWare folders, enable [NetWare] in [Effective Protocol].
C
If necessary, change settings in [Send Settings] under [Scanner Features].
Note
❒ To connect the machine to the network using an IEEE 1394 cable or wire-
less LAN (IEEE 802.11B), an extended 1394 board or extended wireless
LAN board is required respectively. For details, see Network Guide.
❒ Items to set up in [System Settings] vary depending on the network environ-
ment. For more information about network settings, see General Settings
Guide.
❒ For more information about [Scanner Features], see General Settings Guide.
❒ Sending files using SMB is available only under a NetBIOS over TCP/IP
environment. Sending files using SMB is not available under a NetBEUI
environment.
❒ Even when settings made with the control panel, Web Image Monitor, Tel-
net, or other methods do not permit the use of SMB and FTP, sending files
by Scan to Folder is still possible.