Renesas Emulation Pod M306H2T-RPD-E - Manual (Page 71)

( 69 / 76 )
(3) Errors Occur When the Emulator Debugger Starts Up
(When the target system is not connected)
Table 6.3 Checkpoints of errors when starting up the emulator debugger (target is not connected)
Error Checkpoint
Check all emulator debugger settings, interface cable
connection and switches on the rear of the PC4701 match.
See the user's manual of the PC4701 and the user's
manual (or online manual) of the emulator debugger.
(1) Download the proper firmware.
See "4.2 Downloading Firmware" (page 48).
(2) Recheck the connection between the PC4701 and
this product.
See "3.6 Connecting the PC4701" (page 41).
Download the proper firmware.
See "4.2 Downloading Firmware" (page 48).
The program may be uncontrollable in areas where
memory is not allocated. Recheck the map setting.
See the user's manual (or online manual) of the emulator
debugger.
(1) The MCU is either in the stop mode or wait mode.
Either reset the MCU or cancel the mode with an
interrupt.
See the MCU specifications.
(2) The program may be uncontrollable in areas where
memory is not allocated. Recheck the map setting.
See the user's manual (or online manual) of the
emulator debugger.
Check the switches in the emulation pod are correctly set.
See "3.2 Setting Switches and Pullup Resistors" (page 29).
Communication error occurred
Data was not sent to the target
Target system cannot be properly built
M3T-PD30 version is not the same version
as the firmware in the target
Target MCU cannot be reset
Target is in HOLD state
Target clock is stopped