Renesas Emulation Pod M306H2T-RPD-E - Manual (Page 46)

( 44 / 76 )
3.8 Making an MCU File for PD30
It is necessary to change the contents of the MCU file according to the MCU to be developed. Make
the MCU file "M306H2.MCU" for M306H2 and store it in the "mcufile" folder in the directory same
as emulator debugger PD30 is stored.
The contents of the MCU file (the SFR area, internal RAM area, internal ROM area, the name of the
firmware file) are shown below. Change the settings according to the MCU to be debugged. Use your
text editor for changing the contents of the MCU file.
The contents of the MCU file when using the M306H2MC are as follows:
0 : SFR area Start address
3FF : End address
400 : Internal RAM Start address
17FF : End address
E0000 : Internal ROM Start address
FFFFF : End address
M30620B : Name of firmware (Do not change.)
0 : Expansion No. PD30 V.4.00 or later required (Do not change.)