Renesas Emulation Pod M306H2T-RPD-E - Manual (Page 34)

( 32 / 76 )
Table 3.3 Switch settings of the M306H2T-RPD-E (3/4)
Switch Signal Jumper switch setting
SW7 Unused
Unused SW8
JC1 FLX JC1 FLX
Connects the SYNCIN pin to the
RCA connector JC1 on the M306H0T-
PRT. (Factory-setting)
SW6 SYNCIN
CVIN1 SW9
Unused SW10
Connects the SYNCIN pin to the
target system via the FLX160.
SYNC/HOR SYNC/HOR
JC2 FLX
Only this setting is available.
(Factory-setting)
JC2 FLX
Do not use this setting.
JC3 FLX
Only this setting is available.
(Factory-setting)
JC3 FLX
Do not use this setting.
JC4 FLX
Connects the CVIN1 pin to the RCA
connector JC4 on the M306H0T-
PRT. (Factory-setting)
CVIN1
JC4 FLX
Connects the CVIN1 pin to the target
system via the FLX160.
CVIN1
JC5 FLX
Only this setting is available.
(Factory-setting)
JC5 FLX
Do not use this setting.