Renesas Emulation Pod M306H2T-RPD-E - Manual (Page 35)

( 33 / 76 )
Table 3.4 Switch settings of the M306H2T-RPD-E (4/4)
Switch Signal Jumper switch setting
VREF1
VR4
FLX
Connects the SVREF pin to the
changeable resistance VR4 on the
M306H0T-PRT. (Factory-setting)
SW11 SVREF
SW12 Unused
SW13 FSCIN
JC4
FLX
Only this setting is available.
(Factory-setting)
FSCIN
4.43 MHz
FLX
Connects the FSCIN pin to the
4.43MHz oscillator circuit on the
M306H0T-PRT. (Factory-setting)
VREF1
Connects the SVREF pin to the
target system via the FLX160.
VR4
FLX
Do not use this setting.
JC4
FLX
FSCIN
Connects the FSCIN pin to the target
system via the FLX160.
4.43 MHz
FLX