Settings required to use e-mail function, Ethernet – Ricoh Aficio MP 161SPF User Manual
Page 29
Network Settings
21
1
Settings Required to Use E-mail Function
This section lists the settings required for sending e-mail.
Ethernet
This section lists the settings required for sending e-mail with Ethernet cable.
For details about how to specify the settings, see "Interface Settings" and "File
Transfer".
Note
❒ For the Effective Protocol setting, check that the protocol you want to use is
set to [Active].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed. If
both Ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
terface takes precedence.
❒ When POP before SMTP is set to [On], also make setting for Reception Proto-
col and POP3/IMAP4 Settings.
❒ When setting POP before SMTP to [On], check POP3 port number in E-mail
Communication Port.
Menu
User Tool
Setting Requirements
Interface Settings/Network Machine IPv4 Address
Necessary
Interface Settings/Network IPv4 Gateway Address
Necessary
Interface Settings/Network DNS Configuration
As required
Interface Settings/Network DDNS Configuration
As required
Interface Settings/Network Domain Name
As required
Interface Settings/Network WINS Configuration
As required
Interface Settings/Network Effective Protocol
Necessary
Interface Settings/Network Ethernet Speed
As required
Interface Settings/Network LAN Type
Necessary
Interface Settings/Network Permit SNMPv3 Communictn.
As required
Interface Settings/Network Host Name
As required
File Transfer
SMTP Server
Necessary
File Transfer
SMTP Authentication
As required
File Transfer
POP before SMTP
As required
File Transfer
Reception Protocol
As required
File Transfer
POP3/IMAP4 Settings
As required
File Transfer
Admin. E-mail Address
As required
File Transfer
E-mail Communication Port
As required