Renesas M3A-HS71 - Manual (Page 35)

Setting Up the Software
3.2.2 Setting Up the E10A-USB Emulator
Rev. 1.01 May 7, 2008 3-9
REJ11J0015-0101
3
3.2.2 Setting Up the E10A-USB Emulator
(i) Setting Up New Firmware
The following explains the case where you set up new firmware of the E10A-USB emulator.
If your E10A-USB emulator already has the firmware suitable for the SH-2A group, skip this step and go to paragraph
(ii) “Setting Up the E10A-USB Emulator Driver.”
Firmware setup requires changing the DIP switch settings on the E10A-USB emulator main unit. Be careful not to
mistake the part of the DIP switch that you need to set. Figure 3.2.8 shows the DIP switch mounted on the E10A-USB
emulator.
Figure 3.2.8 DIP Switch on the E10A-USB Emulator