Raymarine SR100 - Manual (Page 11)

8
Cable runs
Consider the following points before installing the system cables:
• You will need to connect the antenna, ethernet and power cables to
the receiver.
• All cables should be adequately clamped and protected from physical
damage and exposure to heat.
• Avoid running cables through bilges or doorways, or close to moving
or hot objects.
Note: Acute bends must be avoided minimum bend radius 25mm.
• Where a cable passes through an exposed bulkhead or deckhead, a
watertight gland or swan neck tube should be used.
• DO NOT cut the cables or remove the connectors.
• DO NOT pull cables through bulkheads using a cord attached to the
connector. This could damage the connector.
• Secure cables in place using tie wraps or lacing twine. Bundling cables
in a way not to produce sharp bends as this can adversely effect the
performance of the SR50/SR100
You will need to run the following cables:
• Power cable.
• SeaTalk hs network cable (SR100 only)
• SeaTalk NG network cable (SR50 only )
• Antenna cable.
• Audio Cable (SR50 only)
Power cable
A 10 ft. (3m) power cable is supplied. This cable has a connector plug for
connecting to the weather receiver at one end and three wires at the other
for connecting to your boats power supply. This cable may be extended to
a distance of 60 ft. (20m) using a suitable wire, gauge AWG 12 or greater.
For full details of power connections refer to “Power cable” on page 15.
SeaTalk
hs network cable (SR100 only)
A 4.9 ft. (1.5m) network cable is supplied. This cable should be used to
connect your SR100 weather receiver to either a SeaTalk hs Network Switch
or cross over coupler to connect to your E Series display or G Series
processor. If a longer cable is required it should be purchased from your
local Raymarine dealer. For full details of available cable lengths refer to
“SeaTalkhs (SR100 Specific)” on page 16.
Seatalk
NG network cable(SR50 only)
A 10ft (3M) Y cable is supplied.This cable makes up a complete terminated
Seatalk NG network and power solution. This cable should be used to
connect your SR50 weather receiver to your C series display and also
supply power to the SeaTalk NG network. If a longer cable is required it
should be purchased from your local Raymarine dealer. The cable supplied
CAUTION
Cables
DO NOT cut cables or remove connectors as this will
severely reduce system performance.
If a longer cable is required you will need to purchase a
replacement cable from a suitable dealer.
If a shorter cable is required, bundle excess cable neatly
and secure out of the way ensuring not to exceed the
minimum bend radius of 25mm.