Renesas Compact Emulator M34571T2-CPE - Manual (Page 49)

M34571T2-CPE User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0972-0100 Rev.1.00 February 10, 2006 Page 47 of 72
3.3 Hardware Breakpoint Setting Window
(1) Breakpoint setup dialog box
1. Opening the hardware breakpoint setup dialog box
2. Hardware Break Point Setting Window in initial state
3. Address event setting dialog box
Hardware breakpoint setup dialog box
You can use a combination of address event (A1 or A2) and
T (external trigger event) as a hardware break event.
Hardware Break Point
Clicking this button opens the hardware breakpoint setup
dialog box.
Setting an address event
You can select one of three conditions, and you can also set
a pass count.
Point:
Specified address
Range In: Specified address range
Range Out: Outside of specified address range
Setting an address event
By selecting A1 or A2, the address event dialog box will be
displayed.
Setting an external trigger event
You can set edges or pass count of external trigger event.
High: Falling edge
Low: Rising edge