Renesas Compact Emulator M34571T2-CPE - Manual (Page 47)

M34571T2-CPE User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0972-0100 Rev.1.00 February 10, 2006 Page 45 of 72
(3) Setting breakpoints
1. Screen after breakpoint setup
Breakpoint setup screen
There are two types of breakpoints as described below. It is
necessary to select the breakpoint by the break mode button.
The current breakpoint is displayed in the break mode
display area.
BM:SW Software
break mode
BM:HW Hardware break mode
.
- Software breakpoint (B)
A software breakpoint can be set or cleared by double-
clicking the breakpoint display area.
If the breakpoint you set is a software breakpoint, the
program stops before executing the instruction at the set
breakpoint. Up to eight breakpoints can be set.
- Hardware breakpoint
A hardware breakpoint can be set or cleared by the
hardware break point setting dialog box.
If the breakpoint you set is a hardware breakpoint, the
program stops after executing the instruction at the set
breakpoint. Up to two breakpoints can be set, and
conditions of an address range or external trigger, etc.,
can be also set.