Regency Liberty L676 - Manual (Page 28)

Regency ® L676 Direct Vent Gas Fireplace 28
INST
ALLA
TION
CONVERSION KIT #521-969 FROM NG TO LP
LP Conversion Kit Contains:
Qty. Part # Description
1 910-462 LP Conversion Coil
1 904-573 Cable Tie
1 910-037 LP Pilot Orifi ce
1 904-345 Orifi ce #53 (back)
1 904-241 Orifi ce #56 (front)
1 904-529 Allen Key
1 918-590 LP Conversion Decal
1 908-528 Red Propane Label
1 918-596 Instruction Sheet
1) Remove the glass door.
a. Release the 2 door latches on the left
and right side at the top of the fi rebox.
b. Swing the door out from the top and
release the hinges on the left and right
side of the door by lifting them up.
Latch
c. Place the door on a soft surface to prevent
scratching.
Hinge
Door
Latch Location
2) Remove the grate by undoing the 2 screws
on the right and left side.
3) Remove the front burner by removing the
screw.
Grate
Front Burner
Front Burner Removed
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER, IF IN DOUBT DO NOT DO THIS CONVERSION!!
LP Conversion instructions for BEFORE UNIT INSTALLATION.
4) Remove the back burner by removing the
screw.
Back Burner
5) Remove the rear log stand by removing
the 4 screws.
Rear Log Stand
INSTALLATION