Roberts Gorden Vantage TF-Series - Manual (Page 28)

ROBERTS GORDON ® T F-S E RIE S S U BMI TT AL S HEE T
© 2004 Roberts-Gordon APPLI CAT IONS, ENGIN EE RING AND DE TAI LE D GUIDANCE ON SYST EMS DE SI GN, I NSTALL ATION AND PRODUCT PE RFORMANCE I S AVAIL ABL E UPO N REQUE ST. ROBERTS GO RDON ® PRODUCTS ARE TO BE
INSTAL LE D ONLY I N ACCOR DANCE WIT H L OCAL L AW S, CODES AND RE GULAT IONS, AND ONLY BY A CONTRACTO R QUALI FIE D IN THE INST AL LAT ION AND SE RVICE OF GAS-F IRE D HEAT ING E QUIPMEN T.
Frame Shield Installation
Reflector Side Extension Installation
Shield
Descr ipti on Part Number
Deco Grille Shield 01365900
NOTE: If the Decorative Grille system is to
be installed in an area with considerable
air movement, it is recommended that one
#8 x 3/8 (3.9 x 9.5mm) sheet metal screw
be installed per reflector extension to
prevent it from blowing over.
A
Reflector Side
Extension
Cut Relief Notches for Tube
and Reflector Hangers
Insert Screw
here
Distance "A" Extension
Mi nimum Maximum Par t No. Width
2" (4 cm) 6" (15 cm) 01370408 8" (20 cm)
6" (15 cm) 10" (26 cm) 01370412 12" (30 cm)
10" (26 cm) 14" (37 cm) 01370416 16" (40 cm)
Description Part Number
Reflector Side Ext ension 01370412