Tv/dvd + hdtv tuner + vcr, Connections & setup, Go to page 14 – RCA Scenium D61W136DB User Manual
Page 9
Connections & Setup
6
Chapter 1
Graphics contained within this publication are for representation only.
Connections & Setup
Chapter 1
7
Graphics contained within this publication are for representation only.
TV/DVD + HDTV Tuner + VCR
1. Make sure cable or antenna and/or satellite is connected to your VCR.
A. Connect the coaxial cable from your cable outlet or antenna to the antenna input on the HDTV Tuner.
B. Connect the satellite dish antenna to the satellite input on the HDTV Tuner.
2. Make the video connection between your HDTV Tuner and the TV/DVD.
A. Best Connection: DVI-HDTV
Connect a DVI-HDTV cable to the DVI-HDTV jack on the back of your HDTV Tuner. Connect the other end of the
cable to the DVI-HDTV input on the back of TV/DVD.
– OR –
B. Very Good Connection: Connect three video grade cables to the CMP1 Y PB PR jacks on the back of the TV/DVD
and to the Y PB PR jacks on the HDTV Tuner.
Notes: The DVI-HDTV and Y PB PR jacks send the digital cable signal to the TV/DVD in digital and analog formats,
respectively.
3. Make the audio connection between your HDTV Tuner and the TV/DVD (to match your video connection).
A. If you used the DVI-HDTV jack:
Connect the audio (white and red) cables to the DVI-HDTV L and R audio jacks on the back of the TV/DVD and to
the Audio Output jacks on the HDTV Tuner.
– OR –
B. If you used the Component Video jacks:
Connect the audio (white and red) cables to the CMP1 L and R audio jacks on the back of the TV/DVD and to the
Audio Output jacks on the HDTV Tuner.
4. Connect your HDTV Tuner to your VCR.
A. Connect a coaxial cable to the HDTV Tuner’s antenna output and to VCR’s antenna input.
B. Connect the audio (white and red) cables to the Audio Output jacks on the HDTV Tuner and to the Audio Input
jacks on the VCR.
C. Connect the video cable to the Video Output jack on the HDTV Tuner and to the Video Input jack on the VCR.
5. Connect your VCR to your TV/DVD.
A. Connect a coaxial cable to the VCR’s antenna output and to the ANTENNA/CABLE Input jack on the TV/DVD.
B. Connect the audio (white and red) cables to the VID2 L/MONO and R audio jacks on the back of the TV/DVD and
to the Audio Output jacks on the VCR.
C. Connect the video cable to the VID2 V (video) jack on the back of the TV/DVD and to the Video Output jack on the
VCR.
Go to page 14