Renesas 32185 - Manual (Page 22)

32185/32186/32192/32195/32196 Group
Starter Kit User’s Manual M3A-2154G52B
REJ10B0223-0150/Rev.1.50 Mar 2008 Page 14 of 80
6.1.2 Starting M3T-PD32RM
Before starting M3T-PD32RM, make sure the hardware components have been set up in
accordance with the instructions in 5.1 M3A-2154 Evaluation Board Hardware Setup, and that
the Starter Kit hardware system (M3A-2154 Evaluation Board and M32100T-EZ-E) have been
powered on. Make sure that M3T-PD32RM cannot be started unless the power to the hardware
system is turned on.
To start M3T-PD32RM, choose
[Start] -> [Programs] -> [Renesas] -> [PD32RM V3.01 Release 00] -> [PD32RM]
from Start menu of Windows. When M3T-PD32RM starts, the initialize dialog box shown in
Figure 6.2 appears. So initialize M3T-PD32RM from this dialog box.
Figure 6.2 M3T-PD32RM Initialize Dialog Box
Setting MCU File
Click the MCU tab in the initialize dialog box (see Figure 6.2) and then the “Refer” button. This
brings up a dialog box for setting MCU files. In this dialog box, select the MCU file described
below.
Table 6.1 MCU File
MCU group name MCU file name
32185 32185.mcu
32186 32186.mcu
32192 32192.mcu
32195 32195.mcu
32196 32196.mcu
This MCU file is stored in directory: (installed location) \ PD32RM \ MCUFILES.
Setting Model
While the MCU tab is open, select the appropriate MCU type from Model selection.
Setting Mode
While the MCU tab is open, select the appropriate MCU operation mode from Mode selection.
Cancel Help