Roland GI-20 - Manual (Page 52)

52
Installing & Setting Up the Driver (Windows)
Open the “Run...” dialog box.
fig.d16
10.
In the dialog box that appears, input the following into the “Open” field, and
click [OK].
D:\WinXP_2K\Setupinf.exe
* The drive name “D:” may be different for your system. Specify the drive name of your CD-ROM drive.
The “SetupInf” dialog box will appear.
You are now ready to install the driver.
fig.d17
11.
Connect the GI-20 to your computer.
1) With the power switch turned OFF, connect the AC adaptor to the GI-20.
2) Connect the AC adaptor to an electrical outlet.
3) Use the USB cable to connect the GI-20 to your computer.
fig.d99
12.
Switch ON the GI-20’s power switch.
USB cable
USB connector of your Computer
Computer
GI-20
Once the connections have
been completed, turn on
power to your various devices
in the order specified. By
turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
other devices.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.