Roland GI-20 - Manual (Page 30)

30
Chapter 3 Convenient Functions Featured by the GI-20
5. Press [WRITE].
The data is transmitted to the external device from the
MIDI OUT and USB connectors.
The following appears in the display during
transmission.
fig.03-08
When the display changes back to “dP,” the
transmission is finished.
6. If using a sequencer as the receiving device, stop
recording.
7. When you have finished the bulk dump, turn the
PARAMETER knob back to “PLAY MODE.”
Receiving Saved Data Using MIDI
(BULK LOAD (MIDI))
Carrying out BULK LOAD automatically overwrites the
settings data stored in the receiving device. Note that this
will result in the loss of the data stored up to that time.
1. Connect the external device’s MIDI OUT to the MIDI
IN on the GI-20.
2. Turn the PARAMETER knob to “BULK.”
fig.03-06
3. Press [SELECT] to select “LM” (LOAD (MIDI)).
fig.03-09
4. Transmit the data from the external device.
The following appears in the display during reception.
fig.03-10
When the display changes back to “LM,” reception is
finished.
5. When you have finished the bulk load, turn the
PARAMETER knob back to “PLAY MODE.”
* If you change to another screen (by pressing [SELECT] or by
turning the PARAMETER knob) while the data is being
received, any data that's been received won't be loaded into the
GI-20.
If necessary, start the Bulk Load procedure over from the
beginning.
When the data is received correctly, the dot on the display will
light.
Flash