Using direct entry, Reference, Modes of operation – RCA RC5231Z User Manual
Page 87: This is important
85
Reference
Using Direct Entry
1.
Turn on the component to be programmed.
2.
Look up the brand and code number(s) for the component on the
code list in this section.
3.
Point the DVD Player’s remote at the component.
4.
Press and hold the component button on the remote you want to
program.
5.
Enter the code from the Remote Control code list (pp. 86-87).
6.
Release the component button, and then press ON•OFF to see if
the component responds to the command. If it doesn’t, try
pressing the component button and then ON•OFF again.
7.
If you get no response, repeat these steps using the next code
listed for your brand, until the component responds to the remote
commands.
To operate another component after you’ve
programmed the remote control:
1.
Press the appropriate component button (TV, VCR1, VCR2, DVD,
AUX or SAT•CABLE) to set the remote to control the component.
2.
Press ON•OFF to turn the component ON or OFF.
3.
Use the remote buttons that apply to that component.
Modes of Operation
Because this universal remote can control several different components
(DVD player, VCR, cable box, etc.) it uses operational modes triggered
by the component buttons. For example if you want the remote to
control the TV, you would press the TV button to put the remote into
TV mode before you could control the TV.
Note:
This remote may not be compatible with all brands and models of
components.
STOP
PAUSE
TV
ON OFF
AUX
DVD
SAT CABLE
RECORD
PLAY
FORWARD
REVERSE
REPEAT
GO BACK
CH
+
CH
-
V
O
L
V
O
L
PLAY MODE
MUTE
INFO
MENU
OK
CLEAR
GUIDE
ANTENNA
1
2
3
4
5
6
7
8
9
0
INPUT
VCR1
VCR2
SUBTITLE AUDIO ANGLE FRAME
SELECT
This Is Important!
You must continue pressing the
component button while you enter the
code.
Let’s say you have a Zenith TV. To
program the remote to operate the TV
you would:
Press and hold the TV button while you
enter the first code listed for Zenith in
the TV Codes column.
Release the TV button. Press ON•OFF
to see if the TV responds. If it doesn’t,
follow the same steps, but enter the
second code instead of the first.