RCA RC5231Z - Manual (Page 10)

8
Setup and Connections
RF Output Adapter Required
You must buy an RF Output
Adapter to use this
connection. You can order
your RF Output Adapter on
page 89, or buy one at your local
electronics store.
CAUTION
Do not stack electronic components or
other objects on top of the DVD Player.
See Safety Information on the inside
front cover.
DVD Player + TV without Audio/Video Input Jacks
(Antenna Jack Only)
1. Insert the RF output adapter into the RF ADAPTER jack on the back of your DVD Player.
2. Connect the coaxial cable from your cable or off-air signal to the Antenna Input jack on the RF output adapter.
3. Connect another coaxial cable to the Antenna Input jack on the back of your TV and to the RF output adapter.
4. If the telephone line cord packed with your DVD Player has a filter attached to one end of the cord, insert that end
of the telephone line cord into the PHONE JACK on the back of your DVD Player. Plug the other end into the
telephone line splitter (provided), and insert the telephone line splitter into a phone jack.
If the telephone line cord doesn’t have a filter attached to it, just insert one end into the DVD Player’s PHONE JACK
and insert the other end into the telephone line splitter. Insert the telephone line splitter into a phone jack.
5. Connect the AC power cord to the AC IN jack on the back of your DVD Player, and plug the other end into an AC
outlet.
6. Turn on your TV.
7. Turn your TV to the RF Output Adapter’s output channel (the adapter should have a CH 3/4 switch on it that
indicates which channel to use on your TV.)
8. Turn on your DVD Player.
ANT IN
TV
DVD
PLAYER
CABLE
OR
OFF-AIR SIGNAL
RF
OUTPUT
ADAPTER
VIDEO OUT
R
AUDIO OUT
RF ADAPTER
AC IN
PHONE
JACK
DIGITAL
AUDIO
OUT L S-VIDEO
To AC Outlet
To Telephone Outlet