Regency P33-NG3 - Manual (Page 29)

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace
OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the
fl ush front. The standard fl ush door and glass
must remain on the unit.
1) Hook the top of the bay door over the fl ush
door fl ange and swing the bottom against
the bottom fl ange of the fl ush door.
2) Secure to the fl ush door bottom bracket with
2 screws provided.
3) Slide the valve extension knobs onto the
valve knobs.
INSTALLATION
Diagram 1 Diagram 2
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located un-
derneath the top of the fi rebox.
2) Install the bottom louver by folding the louver
down and then sliding the Bottom Louver
bracket down onto the 2 pins on the base
of the unit (dia. 1). Secure with 1 screw as
per dia. 2.
Note: Top and
bottom louvers
are different.
3) Open the bottom louver. Pull the Burner
ON/OFF control box from inside the bottom
of the fi replace and position the slots in the
bracket over the 2 screws on the left side of
the bottom louver. Push down to lock into
place. Tighten the screws.
Screws on lou-
ver bracket
Burner ON/OFF control box attached to bot-
tom fl ush louver.
Burner ON/OFF
control box
Note: If any maintenance etc. must be done
in the fi rebox, fi rst remove the Bay
louvers and door.
Optional Bay Trim
Attach 4 supplied magnets each to the back of
the top and bottom trim pieces, and attach trim
to the top and bottom of Bay door.
DOUBLE SCREEN
DOOR
1) Pull out the top louver.
2) Center the screen door and hook over the
fl ush door.
3) Open the screen door(s) and secure the
screen door to the fl ush door front with 2
clips on the bottom left and right side.
Clip locations
Clip installed on right side.