Ricoh Aficio LD132c - Manual (Page 90)

Registering Addresses and Users for Facsimile/Scanner Functions
78
5
To use the Fax destination as the
sender
You need to register the user code
in advance.
⇒ p.72 “Registering a
New User Code”
A Press [Protection].
B Press [Sender].
C Press [OK].
To select the line
A Press [Select Line].
B Select the line, and then press
[OK] .
To program the SUB Code
A Press [Adv. Features], and then
select [SUB Code].
B Press [Change] under TX SUB
Code.
C Enter a SUB Code using the
number keys, and then press
[OK]
.
D To enter a password, press
[Ch an g e ] under P ass word
(SID).
E Enter a password using the
number keys, and then press
[OK]
.
F Press [OK].
To program the SEP Code
A Press [Adv. Features], and then
select [SEP Code].
B Press [Change] under RX SEP
Code.
C Enter a SEP Code using the
number keys, and then press
[OK]
.
D To enter a password, press
[ Ch an g e] und er P as sword
(PWD).
E Enter a password using the
number keys, and then press
[OK]
.
F Press [OK].
To set the International TX Mode
A Press [Change] under Interna-
tional TX Mode.
B Select [Off] or [On], and then
press [OK].
To select the fax header
Note
❒ You can register the fax header
in Program Fax Information in
the system settings for Facsimi-
le Features. See “Program -
ming”, Facsimile Reference Features>.
A Press [Change] under Fax Head-
er.
B Select [1st Name] or [2nd Name],
and then press [OK].
To set label insertion
When Label Insertion is set to ON,
the receiver's name and standard
messages are printed on the fax
message when it is received at the
other end.
A Press [Change] under Label In-
sertion.
B Select [On].
C Press [Change] under Line 2.
ThemisC1_AE_zentai_pre_FM.book Page 78 Thursday, July 28, 2005 2:13 PM