RCA Scenium PHD50400 - Manual (Page 28)

Chapter 2 27
The Menu System
Turning the Picture Back On
POWER
SAVER
Mode POWER/
STANDBY
indicator Power Saver
Operating
Status
Description
On
Standby
Suspend
Off
Green
Yellow
Red
Red
Not activated
Activated
Activated
Activated
Horizontal and vertical
synchronizing signals are present
from the computer.
No horizontal synchronizing
signals are present from the
computer.
No vertical synchronizing signals
are present from the computer.
No horizontal and vertical
synchronizing signals are present
from the computer.
Picture already on.
Use the keyboard or mouse. The
picture reappears immediately.
Use the keyboard or mouse. The
picture reappears, but more slowly
than when in standby mode.
Use the keyboard or mouse. The
picture reappears, but more slowly
than when in either standby or
suspend mode.
POWER/STANDBY indicator
This is the FUNCTION menu with the POWER SAVER
option highlighted.
: ON
: 1
: ON
: 3
: ON
: 1
F U N C T I O N
SEL. ADJ.
DISPLAY
MENU ADJUST
POWER SAVER
GRAY LEVEL
FILM MODE
RGB3 ADJ.
SCREEN SAVER
RESET
RETURN
Setting the POWER SAVER for Computer Images
The POWER SAVER function can be used when the signal source to the monitor
comes from a computer conforming to the VESA DPMS format. This function
automatically reduces the monitor’s power consumption if no operation is
performed for a certain amount of time. POWER SAVER can be turned on or off.
If the computer’s power isn’t turned on or if the computer and selector tuner
are not properly connected, POWER SAVER is set to OFF.
For instructions on using the computer’s power management function, see your
computer’s operating manual.
To turn the monitor’s POWER SAVER function on or off:
1. From the main menu, highlight and select FUNCTION. The FUNCTION menu
is displayed.
2. Highlight the POWER SAVER option.
3. Use the button to toggle the setting ON or OFF.
4. You can continue making adjustments in the FUNCTION menu, return to the
previous menu by pressing the GO BACK button or press CLEAR to exit the
menu system.
The POWER/STANDBY indicator shows the status of the POWER SAVER function.
See below for status and description.