RCA Scenium PHD50400 - Manual (Page 14)

Chapter 1 13
Connections and Setup
Using Your Remote Control
Use your remote control from a distance of about 7m/23 feet from the
monitor’s remote control sensor and at a horizontal angle of within 30
°
. The
remote operates on line of sight, so if there is anything blocking the path
between the remote and the remote control sensor on the front of the
monitor, the remote may not work.
• Don’t expose the remote control sensor on the front of the monitor to
direct sunlight or strong artificial light.
• Don’t get the remote control wet.
• Avoid heat and humidity.
• When not using the remote for a long period of time, remove the batteries.
Programming the Remote
The universal remote control that came with your monitor is already
programmed to operate most RCA, GE, and PROSCAN VCRs, DVD players,
laserdisc players, and satellite receivers. This remote is also capable of
operating many other brands of remote-controllable electronic components,
but you must program it to do so.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed, turn on
one of your components, such as a VCR. Point the remote control at the
component and press the component button (for example, the VCR button).
Now press the ON•OFF button on the remote. If the component doesn’t turn
off, you need to program the remote control in order for it to operate that
component.
INPUT SELECT
POWER STANDBY
VOLUME
Approx.
7m/23 ft.
30
°
30
°
STOP PAUSE
MONITOR ON OFF
AUX DVD SAT CABLE
RECORD
PLAY FORWARD REVERSE
SLEEP GO BACK
CH +
CH - V O L V O L
WHO MUTE
INFO
MENU CLEAR
GUIDE
ANTENNA
1 2 3
4 5 6
7 8 9
0 INPUT
VCR1
VCR2
OK
ZZZ
CINEMA VGA VIDEO Y u v
SOURCE
How to Program the Remote
1. Turn on the component you want the remote to operate (the red light on the remote turns on).
2. Look up the brand and code number(s) for the component on the code liston the following pages.
3. Press and hold the component button that corresponds to the component you want the remote to
operate (VCR, RCA DVD, etc.).
4. Enter the code from the code list. When you begin entering numbers, the red light on the remote
turns off. When the last number is entered, the red light turns back on. If the incorrect code is
entered, the red light will flash.
5. Release the component button. The red light on the remote turns off.
6. Press ON•OFF to see if the component responds to the remote commands. If it doesn’t, try pressing
the component button and then ON•OFF again.
6. If you get no response, repeat these steps using the next code listed for your brand, until the
component responds to the remote commands.