RCA Scenium PHD50400 - Manual (Page 18)

Chapter 2 17
The Menu System
Basic Operations
Power
To turn the monitor on and off:
1. Plug the power cord into an active AC power outlet.
2. Press the ON•OFF button on the remote control or the monitor button on the unit. The monitor’s POWER/STANDBY indicator turns
green when the monitor is on.
3. Press the ON•OFF button on the remote control or the unit to turn it off. The monitor’s POWER/STANDBY indicator turns red and
the standby mode is set (only when turning off the unit with the remote control).
Volume
To adjust the volume:
1. Press and hold the VOL > button (on the remote control or the unit) to increase to the desired level.
2. Press and hold the VOL < button (on the remote control or the unit) to decrease to the desired level.
Note: External speakers are required for sound.
Mute
Press the MUTE button on the remote control to reduce the sound to an inaudible level. Press MUTE again to restore the sound.
Zoom
INFO
MENU
OK
CLEAR
GUIDE
ZOOM
These are the buttons on the
remote you use to navigate through
the monitor’s on-screen menu
system.
1. Press the ZOOM button to display thee zoom pointer.
2. Press CH+ to enlarge the picture. Use the arrow buttons to pan right, left, up and
down.
3. To reduce the picture, press the CH- button.
4. Press the ZOOM button to remove the pointer and take the display out of zoom mode.
Navigating the Menus
You can adjust monitor options through the monitor’s menu system. To access the main
menu, press the MENU button on the remote control or MENU•OK on the front of the
monitor.
There are a few things you need to know to navigate through the menu system. The
navigation buttons are the set of arrow-shaped buttons in the middle of the remote (See
illustration on left).
Use the ▲ and ▼ buttons on the remote to move the menu highlight up and down.
Use the and buttons to move the highlight and change settings.
Press the GO BACK button on the remote to return to a previous menu.
You can return the monitor to the factory settings at any time by using the RESET option
in the FUNCTION menu. Remember, if you choose to reset, ALL settings will return to the
factory settings.
Chapter 2 The Menu System