Radio Shack 43-142 - Manual (Page 20)

The Basics
0
Installing a Belt Clip
To Attach the Belt Clip, insert the belt clip into
the holes on each side of the handset. Press
down until it clicks.
To Remove the Belt Clip, pull either side of the
belt clip to release the tabs from the holes.
Using an optional Headset
You can make or answer calls handsfree using an optional
headset that has a 3/32-inch (2.5-mm) plug. Your local
RadioShack store has a variety of headsets available.
To connect the headset, gently flip open
the rubber headset jack cover on the side
of the handset. Then insert the headset’s
plug into the jack.
Use
or on the handset to adjust the
headset’s volume.
With a headset connected, you can make
or answer calls as usual using the keys on
the handset.
When you finish using the headset, disconnect it from the
handset and close the rubber cover to protect the jack.
NOTES
Always place the handset properly on the base
or charger whenever you are recharging the
handset.
You can use a handset holder (available from
your local
RadioShack store) to hang the handset
on your belt for added convenience.
•
•
1.
2.
3.
4.