Radio Shack 43-142 - Manual (Page 17)

1
The Basics
On a Wall Plate or Wall
To mount the phone directly on a wall, you need two screws (not
supplied) with heads that fit into the keyhole slots on the base.
Drill two holes 3 15/16 inches apart. Thread a screw into each
hole, letting the heads extend about 1/8 inch.
Plug the supplied AC adapter’s barrel plug into the DC IN 9V
jack on the back of the base.
Route the adapter cord through the base’s groove.
Plug one end of the supplied modular cord (short for a wall
plate, long for direct wall mounting) into the TEL LINE jack on
the back of the base.
Insert the two tabs at the bottom
of the narrow end of the supplied
bracket into the base’s lower tab
slots. Then press down on the
bracket’s latches and insert them
into the upper slots.
Plug the adapter
into a standard AC
outlet. Plug the
modular cord’s
other end into a
modular phone line
jack.
For a wall plate,
align the base’s
keyhole slots with
the wall plate studs
and slide the base
downward to secure it.
1.
2.
3.
4.
5.
6.
7.