Runco VX-44D - Manual (Page 65)

Installation
Runco VX-44d/-55d Installation/Operation Manual 49
PRE
L
IMINAR
Y
3.13
Working With the
Lamp Access the Lamp Adjust menu to:
• Choose a lamp mode for regulating power and light output.
• Change the optical aperture size.
• View information pertaining to past and present lamps.
To access the Lamp Adjust menu, press MENU on the VX-44d/-55d built-in keypad
(Figure 2-3). Then, Select Lamp Adjust from the Main Menu.
Lamp Hours (read-only): Lamp Hours shows the number of hours logged on the
current lamp. Whenever you record a new lamp serial number, the VX-44d/-55d
automatically resets this value to zero and begins to log time for the new lamp.
Lamp S/N (read-only): Lamp S/N is the serial number recorded for the current lamp.
When you install a new lamp and enter its serial number, the number appears here.
Lamp Message: Enter a check mark for Lamp Message to enable a warning message
that appears upon power-up when the lamp has reached the specified lamp limit and
should be replaced. Delete the check mark to prevent display of this message – instead,
when your lamp expires, only the status display messages on the back of the projector will
provide a visual warning to replace the lamp.
Lamp Limit: Set Lamp Limit to the number of hours you expect to log on the current
lamp before replacing it. This will trigger a lamp message on-screen (if enabled).
Lamp Hours 147
Lamp S/N 123456789
1. Lamp Message
2. Lamp Limit 1000
3. Lamp Mode Power
4. Power 500
5. Intensity 0
6. RVR 3
7. Lamp History
8. Change Lamp
Lamp Adjust
You can also perform this task through the DHD Controller. For
more information, refer to Lamp on page 66.
You can also perform this task through the DHD Controller. For
more information, refer to RVR on page 68.
You can also obtain this information through the DHD Controller.
For more information, refer to Lamp Info on page 72.
For detailed lamp replacement instructions, refer to Lamp and
Filter Replacement on page 77.
1. It is recommended that the Lamp Message check box remain
enabled.
2. When a lamp warning message appears, press EXIT to
temporarily dismiss the warning. The message will continue to
appear upon power-up until you install a new lamp.
Note
Note
Note
Note
Note