Runco VX-44D - Manual (Page 101)

Maintenance and Troubleshooting
Runco VX-44d/-55d Installation/Operation Manual 85
PRE
L
IMINAR
Y
Panel Driver and Formatter
80 Unrecognized Panel Driver.
81 Unable to program device on Panel Driver.
82 TI flash download failure.
83 TI flash download failure.
84 TI flash download failure.
85 TI-I2C write failure.
86 One or more formatters not responding; probable formatter software fault.
87 Formatter reports RDRAM failure.
88 Red modular Formatter communication failure.
89 Green modular Formatter communication failure.
8A Blue modular Formatter communication failure.
93 Modular formatter architecture error.
94 Modular formatter DMD mismatch.
95 Modular formatter sequence mismatch.
Miscellaneous
A0 Unable to program the optional module.
A1 Unable to power the optional module.
A2 Unable to program the Dual Slot Backplane Module (DSBP).
A3 Unable to program the optional Post Processing Module (Warp module).
Table 5-2. VX-44d/-55d Error Codes (continued)
Code Description
Note: To clear a system error, press the EXIT key (on the projector’s built-in keypad) twice. If
necessary, reset the projector by powering it off, allowing it to cool and powering it on again.
Contact your Runco dealer or Runco technical support if the error persists.