Radio Shack 43-3871 - Manual (Page 9)

Installation
9
On a Desk Top
1. Plug one end of
the supplied long
modular cord into
the
TEL LINE jack
on the back of
the base.
2. Plug the modular
cord’s other end
into a modular
phone line jack.
3. Insert the supplied AC adapter’s barrel
plug into the DC IN 9V jack on the back
of the base.
4. Route the adapter’s cord through the
strain relief slot on the base, then plug
the adapter into a standard AC outlet.
5. Lift the base’s antenna to a vertical
position.
On a Wall Plate or Wall
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the base.
Drill two holes 3
15 /
16
inches apart. Thread a
screw into each hole, letting the heads
extend about
1 /
8
inch.
1. Detach the bracket from the bottom of
the base.
2. Insert the two
tabs at the top of
the narrow end of
the supplied
bracket into the
base’s upper tab
slots, then press
down on the
bracket’s latches
and insert them into the lower slots.
TEL
LINE DC IN 9V
CAUTION
You must use
a Class 2
power source
that supplies 9V DC and
delivers at least 400 mA.
Its center tip must be set
to positive and its plug
must fit the phone’s
DC
IN 9V jack. The supplied
adapter meets these
specifications. Using an
adapter that does not
meet these
specifications could
damage the phone or
the adapter.
!