Radio Shack 43-3871 - Manual (Page 29)

Making and
Receivin
g Calls
29
A
DJUSTING THE
H
ANDSET
R INGER , E ARPIECE AND
S PEAKER V OLUME
You can adjust the handset ringer and
earpiece/speaker volume separately.
Press the volume up key or volume down
key (labeled as
VOL/RING/ or VOL/RING/
in standby mode to select one of three ringer
volume (off, low, or high).
Pressing the volume up key or volume down
key (labeled as
VOL/RING/ or VOL/RING/
key) during a call will change the earpiece
and speaker volume of the handset. This
setting will remain in effect after the
telephone call has ended.
D O N OT D ISTURB (DND)
DND allows you to mute the ringer of the
handset and the base at once. Additionally,
if you have more than one handset, ringer
for all handsets will be muted. To do this, In
the standby mode, press and hold
DO NOT DISTURB on the base. You will hear
a confirmation tone and the
DO NOT DISTURB LED right. To cancel
ringer mute, press DO NOT DISTURB again.
You can also mute the ringer tone while the
phone is ringing by pressing
DO NOT DISTURB on the base. Ô
To mute the ringer tone for each handset or
the base temporarily, when the phone is
ringing:
• Press END on a handset, or
• Press XPLAY/ STOP on the base.
The ringer tone will return to the previous
setting starting with the next incoming call.
Ô
NOTES
Ô
Adjusting the Handset
Ringer, Earpiece and
Speaker Volume
•
Standby Mode - The
handset is not in use and
TALK/FLASH has not
been pressed.
• When you press volume
up key (
VOL/RING/ )
in the maximum volume
level or volume down
key (
VOL/RING/ ) in
the lowest volume level,
an error tone sounds.
Do not Disturb (DND)
•
Setting the DND to on
while the answering
system off, turns the
Answering system on
automatically. The
Answering system
setting will return to the
original setting when you
cancel the DND.
• If you press ANSWER
when the DND and the
answering system is on,
both of the DND and the
answering system will
turn off.