Rinnai RHFE-308 FTR - Manual (Page 31)

– 31 –
FITTING UNIT
AIR INLET HOSE
EXHAUST PIPE & LOCKING CLAMP
The following components can be fitted by reaching
down the rear of the appliance as it is positioned
against the wall.
Manifold
a
b
Attach the Air Inlet Hose to the flue manifold
on either inlet position a or b. The unused
inlet is plugged with the rubber cap supplied
on the manifold.
1.
Connect the flue elbow to the manifold by
moving the appliance into position.
2.
Fit the locking clamp over the connection
between the flue elbow and the manifold.
Engage the hook and rotate it until it snaps
against the body of the clamp.
Locking clamp
Elbow
Manifold
Hook
Locking Clamp
Elbow
Locking clamp
Manifold
3.
Fit Clip
Slide
Sock
4.
Slide the insulation sock up to the flue
manifold and slip the securing clip over the
sock as shown.