Rinnai RHFE-308 FTR - Manual (Page 14)

– 14 –
SETTING THE CLOCK
When the appliance is first plugged in and then turned on, the Digital Display will show .
As an example, let’s set the clock to 10:35 am.
OPEN THE CONTROL PANEL - SEE PAGE 10.
1
When the appliance is first plugged in or after a
power failure, the Digital Display will show
.
Press the Set Times button once, the Clock Indicator
will flash.
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
2
Press and hold the “ ” button; the minutes will
begin to change first, then the time will change by
whole hours. Release the button when AM 10:00
shows on the Digital Display. Confirm that you have
selected AM, a small indicator on the left hand side of
the Digital Display indicates the AM setting.
Press and hold the “ ” button again, release the
button when AM 10:35 shows. If you go past AM
10:35, then the “
” button can be used to change
the time settings in reverse.
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
3
Press the Timer Set button five times to lock in and
complete setting the time. The Clock and Timer
indicators will go out. A small indicator on the Digital
Display will flash to show that the clock is operating.
AM
PM
Set Room
Temp
Time
Set times
Clock
Timer 1
Timer 2
on off
DIGITAL DISPLAY
TIMER/CLOCK SET
ON-OFF SWITCH
ON-OFF SWITCH INDICATOR
TIMER/CLOCK SET INDICATOR
TIMER/TEMP ADJUSTMENT