Nortel Networks S4000 - Manual (Page 180)

168
Troubleshooting
T
e
ch
n
ical
No
te
s an
d I
n
de
x
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Date not appearing on pictures
even when
Date imprint is
enabled.
The current shooting mode is one that does not
support
Date imprint.
145
Camera settings reset.
Clock battery is exhausted; all settings were
restored to their default values.
142
Monitor turns off, and the
power-on lamp blinks rapidly.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
After the lamp blinks for three minutes, the
camera will turn off automatically. Pressing the
power switch also turns off the camera.
21
Battery inserted into the
camera is not charged when
the camera is connected to a
computer.
• The battery is not charged when the camera
is turned off.
• Charging stops if the computer enters sleep
mode while the battery is charging. The
camera may be turned off.
• Depending upon computer specifications,
settings, and status, it may be impossible to
charge the battery inserted into the camera
via computer connection.
131
Problem Cause/Solution A