Nortel Networks S4000 - Manual (Page 158)

146
Setup Menu
Basi
c Came
ra Setup
B
Notes on Electronic Vibration Reduction
• Electronic VR does not function when the flash is used, except when slow sync mode is applied.
Electronic VR does not function when slow sync with red-eye reduction ( A 63, 64) is used.
• Electronic VR does not function with exposures that exceed a certain length of time.
• Electronic VR is activated only when ISO sensitivity (A 54) is set to Auto.
• Electronic VR does not function in the following scene modes.
-
Sports (A 63)
-
Night portrait (A 63)
-
Dusk/dawn (A 65)
-
Night landscape (A 65)
-
Museum (A 66)
-
Fireworks show (A 67)
-
Backlight (A 67)
• Electronic VR does not function when Blink proof (A 74) is set to On.
• The effectiveness of electronic VR decreases as camera shake increases.
• The pictures taken using electronic vibration reduction may be somewhat “grainy” in appearance.
D
Electronic VR for Movies
To compensate for camera shake with movie recording, enable
Electronic VR (A 122) from the
movie menu ( A 121).
Motion Detection
Enable motion detection to reduce the effects of subject movement and camera
shake when shooting still pictures.
Tap F M z (Setup menu) (A 139) M Motion detection
Auto (default setting)
When the camera detects the subject movement or camera shake, the ISO
sensitivity and shutter speed are automatically increased to reduce blurring.
However, motion detection does not function in the following situations.
• Subject tracking is selected for the touch shooting setting
• When the flash fires
• When ISO sensitivity (A 54) is set to Fixed range auto, or ISO sensitivity is
fixed at a particular value in A (auto) mode
• When Multi-shot 16 (A 53) is selected
• When Sports (A 63), Night portrait (A 63), Dusk/dawn (A 65), Fireworks
show (A 67), or Backlight (A 67) scene mode is enabled
• When recording movies
Off
Motion detection is not enabled.