NetComm HS1100 - Manual (Page 39)

HS1100 Wireless Hotspot Gateway User Manual
38
¾ WDS Settings:
Choose WDS Setting to configure the settings. This function can extend the range of accessing the
network. When this function is enabled, please enter the MAC address of the repeater in the blank and
choose Security Type.
y Wireless Configuration
IP PNP: Choose to enable or disable this function. If “IP PnP” is enabled, no matter what the IP address of the
client device is – static or dynamic IP, users can access the network without changing the client IP address after
being authenticated by HS1100.
User Authentication: If “User Authentication” is disabled, “Specific Route Profile” needs to be specified for
users to access the Internet.
Operation Mode: Select one from the two modes, NAT mode and Router mode, by the requirements.
IP Address: Enter desired IP address for the wireless port.
Subnet Mask: Enter desired subnet mask for the wireless port.