Call settings, Gprs – Nokia 3200 User Manual
Page 44
M e n u f u n c t i o n s
Copyright © 2004 Nokia. All rights reserved.
33
Checking the status of the infrared
connection
• When
is shown continuously,
the infrared connection is active
and your phone is ready to send or
receive data via its infrared port.
• When
blinks, your phone is
trying to connect to the other
device or the connection has been
lost.
GPRS
In this menu you can define when the
phone connects to the (E)GPRS
network (network service). For general
information about the (E)GPRS service,
see page
To access this menu: Press
Menu
in
standby mode, and select
Settings
,
Connectivity
and
GPRS
.
Select
GPRS connection
and
Always
online
or
When needed
.
• If you select
Always online
, the
phone automatically registers to a
(E)GPRS network when you switch
the phone on, if the (E)GPRS
network is available in your
location.
If you select
When needed
, the
phone registers and connects to
the (E)GPRS network only if you use
a function that needs the (E)GPRS
service. In this case, establishing
the connection may take longer
than when
Always online
is
selected.
GPRS indicators
When the selected (E)GPRS connection
mode is
Always online
and the (E)GPRS
service is available, is shown on the
display.
When you start a function that uses
the (E)GPRS service, the phone
connects to the (E)GPRS network, is
shown and data transfer is possible.
If you receive a call or a text message,
or make a call, during a (E)GPRS
connection,
is shown to indicate
that the connection is suspended (on
hold). The phone tries to re-establish
the connection after the call.
Call settings
To access this menu: Press
Menu
in
standby mode, and select
Settings
and
Call settings
. Select
•
Call divert
to direct your incoming
calls to your voice mailbox or to
another phone number (network
service). Divert options that are not
supported by your SIM card or your
network operator may not be
shown.
Select the desired divert option, for
example,
Divert if busy
to divert
voice calls when your number is
busy or when you reject an
incoming call. Set the divert option
on (
Activate
) or off (
Cancel
), or
check whether the option is
activated (
Check status
).