Keypad lock (keyguard), Using the loudspeaker, Writing text – Nokia 3200 User Manual
Page 20: Predictive text input, Keypad lock (keyguard) using the loudspeaker

B a s i c f u n c t i o n s
Copyright © 2004 Nokia. All rights reserved.
9
■ Keypad lock (Keyguard)
You can lock the keypad to prevent the
keys being accidentally pressed, for
example, when your phone is in your
handbag.
To lock the keypad, press
Menu
in
standby mode and then
within 1.5
seconds. When the keypad is locked,
is shown at the top of the display.
To unlock the keypad, press
Unlock
and
within 1.5 seconds.
When the keypad is locked, you can
answer a call by pressing
. During a
call, the phone can be operated
normally. When you end or reject the
call, the keypad will automatically be
locked.
You can also set the keypad to lock
automatically after a certain length of
time. See
Automatic keyguard
on page
Note: When Keyguard is on,
calls may be possible to the
emergency number
programmed into your phone
(e.g. 112, 911 or other official
emergency number). Key in
the emergency number and
press
. The number is
displayed only after you have
keyed in its last digit.
■ Using the loudspeaker
The phone has a loudspeaker that
allows you to use the phone hands free
during a call. Do not hold the phone to
your ear during loudspeaker operation
as the volume may be extremely loud.
To activate the loudspeaker: Press
Options
during a call and select
Loudspeaker
, or press
Loudsp.
if
available. When the loudspeaker is
active,
is shown in standby mode.
To deactivate the loudspeaker: Press
Options
and select
Handset
, or press
Handset
if available.
■ Writing text
You can key in text, for example
messages or calendar notes, using
predictive or traditional text input.
Predictive text input
In predictive text input, you can key in
characters by pressing a letter key
once for each character. This input
method uses a dictionary built into the
phone.
Setting predictive text input on
or off
When writing text, press
Options
and
select
Dictionary
.
• To set predictive text input on,
select the language you want from
the dictionary list.