Nikon D300s - Manual (Page 158)

132
Z
❚❚Canceling Bracketing
To cancel bracketing, press the Fn button and rotate the main
command dial until the number of shots in the bracketing
sequence is zero. The program last in effect will be restored the
next time bracketing is activated. Bracketing can also be cancelled
by performing a two-button reset (
0 182), although in this case
the bracketing program will not be restored the next time
bracketing is activated.
A ADL Bracketing
In continuous low speed and continuous high speed modes, shooting
will pause after the number of shots specified in the bracketing
program have been taken. Shooting will resume the next time the
shutter-release button is pressed. In other modes, one shot will be
taken each time the shutter-release button is pressed.
If the memory card fills before all shots in the sequence have been
taken, shooting can be resumed from the next shot in the sequence
after the memory card has been replaced or shots have been deleted to
make room on the memory card. If the camera is turned off before all
shots in the sequence have been taken, bracketing will resume from the
next shot in the sequence when the camera is turned on.