National Instruments SCXI-1120 - Manual (Page 39)

Chapter 2 Configuration and Installation
© National Instruments Corporation 2-23 SCXI-1120 User Manual
Terminal Block Installation
To connect the terminal block to the SCXI-1120 front connector, perform the following steps:
1. Connect the SCXI-1120 front connector to its mating connector on the terminal block.
2. Make sure that the SCXI-1120 top and bottom thumbscrews do not obstruct the rear panel of
the terminal block.
3. Tighten the top and bottom screws on the back of the terminal block to hold it securely in
place.
Rear Signal Connector
Note: If you will be using the SCXI-1120 with a National Instruments data acquisition board
and cable assembly, you do not need to read the remainder of this chapter. If you will
also be using the SCXI-1180 feedthrough panel, the SCXI-1343 rear screw terminal
adapter, or the SCXI-1351 one-slot cable extender with the SCXI-1120, you should read
this section.
Figure 2-11 shows the pin assignments for the SCXI-1120 rear signal connector.