National Instruments SCXI-1120 - Manual (Page 105)

Appendix E SCXI-1120 Cabling
© National Instruments Corporation E-7 SCXI-1120 User Manual
1. Make sure that the computer and the SCXI chassis are turned off.
2. Remove the front filler panel of the slot where you will insert the SCXI-1180.
3. Thread the rear connector through the front of the chassis to the rear of the chassis. Attach
the rear connector to the breakout connector of the adjacent cable assembly or slot extender,
as shown in Figure E-2.
Step 3
SCXI-1180
Breakout Connector
Ribbon Cable to
Front Panel
Rear Connector
Breakout Connector
from SCXI-1340
Threaded Strip in
Rear of Chassis
Step 4
Rear
Panel
Figure E-2. SCXI-1180 Rear Connections
4. Screw in the rear panel to the threaded strip in the rear of the chassis.
5. Screw the front panel into the front threaded strip, as shown in Figure E-3.
Check the installation.