NAD S170iAV - Manual (Page 37)

37
ENGLISH
FRANÇAIS
DEUTSCH
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
TROUBLESHOOTING
CONDITION POSSIBLE CAUSE(S) POSSIBLE SOLUTIONS(S)
NO SOUND FROM ALL CHANNELS • AC power unplugged
• power not switched on
• outlet is un-powered
• Tape Monitor is engaged
• Check AC cable, connection, and outlet
• disengage Tape Monitor
NO SOUND FROM SOME CHANNELS • Faulty/missing cables
• channel(s) set to “No”
• power-amp or speaker-connections faulty
• Check cables
• check menu
• check power amp, cabling, and speakers
NO SOUND FROM SURROUND CHANNELS • No surround listening mode is engaged
• surround-channels set to “No” on setup> menu
• surround-channels level set too low on setup> menu
• Select appropriate listening mode
• correct or
settings
NO SOUND FROM SUBWOOFER • Subwoofer is off, unpowered, or improperly
connected
• subwoofer set to “No” on
menu
• sub level set too low on menu
• Power-up subwoofer, check sub’s AC outlet or
check connections
• correct or
settings
NO SOUND FROM CENTER CHANNEL • Source is a 2/0 (etc.) Dolby Digital or DTS
recording without center channel
• center set to “No” on menu
• center level set too low on menu
• Play a known 5.1-channel recording or select
Dolby Pro Logic or Mono mode
• correct or
settings
NO DOLBY DIGITAL/DTS • Source’s digital output is not connected to an
S170i digital input • Check connections
S170I DOES NOT RESPOND TO HTR 2 REMOTE • Batteries are flat or incorrectly inserted
• IR transmitter window on remote, or IR receiver
window on S170i is obstructed
• S170i front panel is in very bright sunlight or
ambient light
• Check batteries
• check IR windows and ensure clear line-of-sight
from remote to S170i
• reduce sunlight/room lighting
S170I DOES NOT RESPOND TO FRONT-PANEL
COMMANDS • Microprocessor error • Power-down the S170i via the front-panel Power
key and unplug it from the AC outlet
• wait five minutes, re-connect and power up