NEC NEAX2000 IVS ND-45492 - Manual (Page 68)

ND-45492 (E) CHAPTER 3
Page 51
Revision 2.0
(6) Connect the bottom PIM and the BASE, and connect PIMs to each other using 3 bolts (provided), as shown
in Figure 003-6 and Figure 003-7 . Then, position the TOP COVER on the top PIM and connect them to-
gether with 4 screws (provided), as shown in Figure 003-8 .
(7) Connect the AC CORD-B to the terminals inside the BASE in the same manner as for the Floor Standing
Installation (Refer to Figure 003-11 through Figure 003-13 ).
(8) When the system is a multiple-PIM configuration, connect the PZ-PW86 cards to each other using PWR
CA-A cables (Refer to Figure 003-14 through Figure 003-15 ).
(9) When the system is a multiple-PIM configuration, mount the PN-BS00 card in the BUS slot of PIM0, and
mount the PN-BS01 card in each BUS slot of PIM1 through PIM7 (Refer to Figure 003-16 ).
Then, connect all the BUS cards (PN-BS00/PN-BS01) to each other using BUS cables (Refer to Figure
003-17 and Figure 003-18 ).
NAP 200-003
Sheet 29/37
Installation of Main Equipment