NEC NEAX2000 IVS ND-45492 - Manual (Page 169)

CHAPTER 3 ND-45492 (E)
Page 152
Revision 2.0
4. System Data Entry
• There are two methods for data entry, both of which employ a CAT or a MAT.
1.3. CAT
Any D
term
can be assigned as a CAT terminal through programming. The D
term
can still be used as a regular
telephone when it is not in CAT mode. If the system is initialized by “A” (Resident System Program), every
D
term
will be able to go into CAT mode. If the system is initialized by “B” (All Clear), only LEN0000 is assigned
as a CAT port (the DLC card must be installed in slot LT00).
To use a D
term
as a CAT, follow the procedures shown below.
To set CAT mode:
(1) Press
(2) Press
• CNF lamp flashes
(3) Press
• CNF lamp is off
(4) Press
(5) Press
• CNF lamp flahses
(6) Press
• CNF, SPKR, ANS lamps are lit
• “CAT MODE” is displayed on the LCD
(7) Press
• “COMMAND = -” is displayed on the LCD
Note: Steps 1 through 6 need to be completed within four (4) seconds.
NAP 200-010
Sheet 2/3
System Initialization and System Data
Entry
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
TRF
CNF
*
TRF
CNF
#
ST