Netopia D3232 IDSL - Manual (Page 123)

Technical Specifications and Safety Information D-123
R R R Ree e eg g g gu u u ullllaa a atttto o o orrrryyy y n n n no o o ottttiiiiccccee e essss
Warning
This is a Class A product. In a domestic environment this product may cause radio inter ference, in which case
the user may be required to take adequate measures. Adequate measures include increasing the physical
distance between this product and other electrical devices.
United States. This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Par t 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful inter ference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful inter ference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful inter ference in which case the user will be required to correct the inter ference at
his own expense. Operation is subject to the following two conditions: (1) this device may not cause harmful
inter ference, and (2) this device must accept any inter ference received, including inter ference that may cause
undesired operation.
Service requirements. In the event of equipment malfunction, all repairs should be per formed by our Company
or an authorized agent. Under FCC rules, no customer is authorized to repair this equipment. This restriction
applies regardless of whether the equipment is in or our of warranty. It is the responsibility of users requiring
ser vice to repor t the need for ser vice to our Company or to one of our authorized agents. Ser vice can be
obtained at Netopia, Inc., 2470 Mariner Square Loop, Alameda, California, 94501.
Important
This product was tested for FCC compliance under conditions that included the use of shielded cables and
connectors between system components. Changes or modifications to this product not authorized by the
manufacturer could void your authority to operate the equipment.
Canada. This digital apparatus does not exceed the Class A limits for radio noise emission from digital
apparatus set out in the Radio Inter ference Regulations of the Canadian Depar tment of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numériques de la classe A prescrites dans le Réglement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.
D D D Dee e eccccllllaa a arrrraa a attttiiiio o o on n n n ffffo o o orrrr C C C Caa a an n n naa a ad d d diiiiaa a an n n n u u u ussssee e errrrssss
The Canadian Industr y Canada label identifies cer tified equipment. This cer tification means that the equipment
meets cer tain telecommunications network protective, operation, and safety requirements. The Depar tment
does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of
the local telecommunications company. The equipment must also be installed using an acceptable method of
connection. In some cases, the company’s inside wiring associated with a single line individual ser vice may be
extended by means of a cer tified connector assembly (telephone extension cord). The customer should be
aware that compliance with the above conditions may not prevent degradation of ser vice in some situations.
Repairs to the cer tified equipment should be made by an authorized Canadian maintenance facility designated
by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may
give the telecommunications company cause to request the user to disconnect the equipment.