Nortel Networks NORSTAR VOICE MAIL 4.0 FAX P0886629 - Manual (Page 62)

62 Appendix B: Dialing Translation
FAX Set Up and Operation Guide P0886629 Issue 1.0
Dialing Translation Table Administration
The System Coordinator is responsible for the creation and maintenance of the
Dialing Translation Table. When using the Fax-on-demand two-call method, you
must set up the Dialing Translation Table.
Setting up a Dialing Translation Table
To set up a Dialing Translation Table, you must enter an Input value and an Output
value for each entry. The Input value is the number that Norstar Voice Mail will
look up in the Dialing Translation Table. After the corresponding entry has been
matched, the Output value is substituted for the Input value. The resulting number
is ready to dial on the local network. Refer to the Dialing Translation Table
examples earlier in this chapter.
To set up a Dialing Translation Table:
1. Press
ƒ · ° ‹.
2. Enter the System Coordinator Mailbox number and
password and press OK.
3. Press
° °.
4. Press TABLE. If Centrex is installed on your Norstar
system, QUIT is replaced by NEXT.
5. Press ADD.
6. Enter the Input value and press OK to accept the
Input value. The Input value can be a maximum of
14 digits.
7. Enter the Output value and press OK to accept the
value. The Output value can be a maximum of 15
digits.
8. You must repeat steps 5 through 7 to add each entry
to the Dialing Translation Table.
9. Press
® to end this programming session.
Log:
QUIT RETRY
Admin
MBOX AA OTHR
Dialing
PARM
QUIT
Dial table
CHNG QUIT
In:
RETRY
Out:
RETRY
Dial table
CHNG QUIT